Creating a Correction Integrity Report

1. Add or Edit an image.
2. On the Where Tab, select the output destination for your report.
3. On the What Account/List Tab, select the Account or List you wish to report.
   Click the Configure Meters/factors button to see the list of Remote Units in the Account or list.
4. Highlight the Remote Units you want to configure or choose all. If you want to find a historical average, click Change to configure the Meter Set (you must set the Corrected and Uncorrected Volume inputs before finding the Historic Average for a Remote Unit).
5. Click Setup to find the Historical Average for the Correction Factor and/or Calculated Pressure. You can run this report using Interval data or daily readings data for a specified time period.
   When calculating Historical Averages, missing data may cause the Reference Correction Factor to be "0". In this case, Highlight
          the Remote Units and manually set reference factors.
6. Click Change to configure the Meter Set. Enter the input numbers for the Corrected and Uncorrected Volume.
7. Enter the Correction Factor with its high and low limits. Enter the Calculated Pressure and Temperature averages with its high and low limits. Press Ok to save all changes.
8. On the What Date/Time Tab, select the Start Date/Time and End Date/Time for which to run the report.
9. On the How Tab, Select the Data Type, Report Type, Report Format, Report Columns, and Data Conversion information.
10. Click Save.
    The report image is saved.
    The specified report period is not saved with the image. If you are going to Autoload the report, you will set up the report period
           in the Autoload Scheduler application.
11. Do one of the following:
    Click Autoload to set up your report for an Autoload
    Click Print to immediately run the report.
    Click Close to exit the Edit Image dialog box.